Outdoor commercial LED screen installation methods and standard steps to introduce 

The use of commercial LED screens can make customers immerse themselves in the space they are shaping and linger. Commercial LED screens combine amusement activities, cultural and recreational facilities, and cultural displays. Commercial LED screen is the unique and distinctive landscape of the whole commercial building. And there are two methods of installation of outdoor commercial LED screens.

•   Commercial LED screen sitting installation

•   Structural frame mosaic installation

Commercial LED screen sit-down installation

Applicable environment: The installation is a flat surface (such as the roof, ground, etc.). 

(1) First of all, consider whether the installation has sufficient load-bearing capacity (the weight of a square meter outdoor display is 65㎏). 

(2) to determine the installation place has enough load-bearing capacity, determine the installation position and do a good job of measurement, mark. Calculate the number of commercial LED screen pendants. 

(3) According to the installation position of the pendant on the box body to fix the outdoor screen display pendant. 

(4) Install the display case. Put the display case on the fixed pendant, and connect the display case and pendant firmly with bolts. 

(5) Install the commercial LED screen display unit. 

According to the bottom to the top, from left to right order to install the display unit, installation of display units to install neatly, and in each display unit before installation in the display unit to tighten the waterproof glass glue, and then the display unit fixed in the box and screwed. 

(6) commercial LED screen around the waterproof treatment 

After all display units are installed, the display unit around the waterproof glass glue, play evenly and firmly. 

(7) check all waterproof glue place 

Waterproof glass glue after playing shall carefully and meticulously check once. See if there is leakage and uneven glue, leakage and uneven glue to replay the waterproof glass glue. Until all the waterproof glass glue is handled properly. 

Structural frame inlay installation 

Applicable environment: Non-bar screen display with an area of more than 5 square meters 

(1) first determine the length and height of the commercial LED screen be installed, to lay a good foundation for the installation process later 

(2) Do the structure 

The structure must take into account the load-bearing capacity of the structure (65㎏ when the weight of a square meter outdoor display). According to the display unit of such display to do structure, the size should be strictly by the specifications of the display unit to determine. 

(3) Installation of display units 

After the structure is finished, start to install the outdoor display unit. Installation of display units must be installed under the order from left to right, from top to bottom. Installation of display units to be installed neatly, and in each display unit before installation in the display unit to be tightened on the waterproof glass glue, and then the display unit fixed in the structure and screwed. 

(4) commercial LED screen around the waterproof treatment 

After all the display units are installed, the display units around the waterproof glass glue, to play evenly and firmly. 

(5) check all the waterproof glue at the waterproof glass glue after playing, must be carefully and meticulously checked once. See if there is leakage and uneven glue, leakage and uneven glue to replay the waterproof glass glue. Until all the waterproof glass glue is handled properly.      

The inspection standard is that the display surface of the commercial LED screen should be flat, the whole plane should not be more than 5㎜ in front and back, and there is no water leakage, Shenzhen Atop Led Opto Electronic Co.